The manufacturer of vortex impurity pump introduces the installation precautions of vortex pump

1. Vortex impurity pump manufacturers should pay attention to keep it stable

In order to ensure the direct connection between the scroll pump and the motor and prolong its service life. Therefore, during installation and calibration, you must ensure that the installation of the whole pump is stable, including its pump shaft and motor output in the same shaft degree.

2. Firmly installed

The stainless steel self-priming pump has very strong power when running. In order to ensure the safe use of the equipment, it is necessary to ensure the firmness between various lock nuts during installation to avoid mechanical failure caused by impeller runout.

3. Retention storage solution

Although the machine pump does not need to be refilled, in order to avoid dry friction inside the machine, a certain amount of storage liquid must be kept in the pump body.

4. Pipe installation

In order to ensure that the pump can complete a good self-priming process, the height of its suction inlet must not exceed 5m. At the same time, the suction port must be used with the support, which can reduce the load of the pipeline. Of course, there must be no solid debris in the pipeline, and the filter surface should be checked regularly. The axial deviation shall be controlled within 0.1mm. When installing the shaft, the large deviation of the shaft must be controlled, otherwise once the height difference is too large, the self-priming pump will lose stability during operation.